Maidaid Halcyon dishwasher troubleshooting

The table below lists the most common dishwasher malfunctions, their causes and methods of possible repair.

Message displayedAnomaly or alarm discovered
E01Rinse not performed (Only versions CRP-SP). This signal appears at the end of the cycle if the working level in the tub is not correctly restored. Check whether the plumbing connections are correct, and that the water supply cock is open. If the problem persists, contact technical service.
E02Water drainage anomaly. Water does not drain or drains abnormally. Check to see if the overflow has been removed. Check the drain tube is not bent or crushed, and that none of the filters are clogged. Run another drain cycle. If the problem persists, contact technical service.
E03Boiler temperature reset anomaly. The boiler temperature reset has not occurred within the time limits set forth in the wash cycle. Turn the machine off and then back on and run another cycle. If the problem persists, contact technical service.
ATub filling time out: the tub has not filled.
E04Check whether the plumbing connections are correct, and that the water supply cock is open. Check the presence of the overflow. If the problem persists, contact technical service.
E05Tub thermometer anomaly. (Probe open) The machine does not measure the temperature in the tub. Turn the machine off and then back on. If the problem persists, contact technical service.
E06Tub thermometer anomaly. (Probe shorted out) Interrupt the programme in progress, and shut off the dishwasheril. Turn it back on after a few minutes and start the cycle again. If the problem persists, contact technical service.
E07Boiler thermometer anomaly. (Probe open) The machine does not measure the temperature in the boiler. Turn the machine off and then back on. If the problem persists, contact technical service.
E08Boiler thermometer anomaly. (Probe shorted out) Interrupt the programme in progress, and shut off the dishwasher. Turn it back on and start the programme again. If the problem persists, contact technical service.
ABoiler fill time out: failure of boiler to fill. Rinsing cannot be performed.
E09• Check that the water supply tap is open.
• Run another complete cycle.
If the problem persists, disconnect the electricity and contact technical service.
“Tank high temp.”Tub temperature too high.
“Boiler high temp.”Boiler temperature too high.
ESFElectromechanical safety: the safety thermostats of the boiler or tub have tripped, or the tub safety pressure switch has intervened. Contact a technical service centre.
A ESLIncorrect tub level: the tub pressure switch has detected a level of water in the tub that is too high or too low. Contact a technical service centre.
E22Tank heating time out: fault during the heating of washing water. Turn the dishwasher OFF and back ON again; in case the problem persists contact an authorised service centre.