CDA Dishwasher Error Codes
CDA Dishwasher Error F1
This refers to an NTC sensor fault , excessively high or excessively lower temperature of the water during the wash cycle, or a fault in the wiring loom.
CDA Dishwasher Error F2
The safety device in the base of the appliance has been operated by a water leak.
The drain pump operates automatically when the anti flood device is activated , also the water valve is switch off
CDA Dishwasher Error F3
The heating cycle is not working. This can occur if the heater heats up too slowly or if the heating element is open circuit.
- A number of other components can also be the cause of this fault;
- A defective electronic pcb
- A fault ntc sensor or a broken wiring loom
CDA Dishwasher Error F4
Water fails to drain within a predetermined time period and the water level indicator senses that water is still in the sump of the dishwasher.
This fault can be caused by a blockage or failure of the drain pump. A faulty water level indicator can also be the cause of the fault
CDA Dishwasher Error F5
Inadequate water supply.
What to do:
- Make sure the water tap is fully open
- Close the water tap, separate the water inlet hose from the tap and clean the filter.
- Restart the dishwasher.
- If the error continues, contact CDA Customer Care
CDA Dishwasher Error F6
No flow of water into the appliance is being recorded by the flow meter.
The causes of this can be an open circuit inlet solenoid valve or a restriction in the water supply to the appliance.
CDA Dishwasher Error F7
This is an indication of a flow meter failure
CDA Dishwasher Error F8
The incorrect water level during any part of the washing cycle. A slow running wash motor causing low water pressure, internal blockages or over sudsing can create this fault code.
CDA Dishwasher Error F9
The dishwasher fills with too much water.
The water valve might not close allowing water constantly to flow into the dishwasher.
A defective control pcb may also be the cause of this fault.
CDA Dishwasher Error FA
The pressure sensing device or water indicator does not switch