Ariston Dishwasher Error Codes

Ariston Dishwasher Error H2O

Ariston Dishwasher Error H2O

It means you have forgotten to turn the water tap on.

Turn on the water tap and the dishwasher will start after a few minutes.

Ariston Dishwasher Error AL06

Ariston Dishwasher Error AL06

If you are not there when the H2O code appears, the appliance will switch to alarm mode and the code AL06 will flash on the display.

Turn the dishwasher off by keeping the Stand-by button pressed in, check the water supply and turn on the water tap, wait approximately 20 seconds before turning appliance back on by pressing the Stand-by button again. Repeat your wash cycle selections and press the Start button

Ariston Dishwasher Error AL05

Ariston Dishwasher Error AL05

This means the filter is clogged.

What to do:

  • Turn the display off by keeping the Standby button pressed
  • When the filter is back in position, turn the dishwasher back on.
  • Repeat your wash cycle selections and press the Start button.

Ariston Dishwasher Error Q

Ariston Dishwasher Error Q

This means the dishwasher has a leak.

What to do:

Switch off and disconnect from the electricity supply.
Check for leaks in the tap and fill hose connections

The dishwasher does not take any water in/Tap shut-off alarm

Several short beeps are emitted) (the ON/OFF indicator light flashes and the number 6 appears on the display.

What to do:

  • There is no water in the mains supply.
  • The water inlet hose is bent
  • Turn on the tap and the appliance will start after a few minutes.
  • The appliance lock has been activated because no action was taken when the beeps sounded. Switch off the machine using the ON/OFF button, turn on the tap and switch the machine back on after 20 seconds by pressing the same button. Re-programme the machine and restart the wash cycle.

Filters and trap blocked alarm

The ON/OFF indicator light flashes and the number 5 appears on the display.
Switch off the appliance by pressing the ON/OFF button, remove and clean the filters, inspect and clean the trap, then switch the machine back on by pressing the same button again. Re- programme the machine and restart the wash cycle.

Water intake solenoid valve malfunction alarm

The ON/OFF indicator light flashes and the number 2 appears on the display

Switch off the appliance by pressing the ON/OFF button and switch it back on after one minute. If the alarm continues, shut off the water tap to eliminate the risk of flooding, remove the plug from the electrical socket and contact Assistance.

Water inlet hose alarm

The ON/OFF indicator light flashes and the number 1 appears on the display
Switch off the appliance by pressing the ON/OFF button. Shut off the water tap to eliminate the risk of flooding, remove the plug from the electrical socket and contact Assistance.